Toss Pillows – First select a fleece. Prints or solid-sided fleece are the best, but only one side can function properly. To launch a 12-inch pillow will have two pieces of fabric 16-inch-by-16-inch required. Buy a large piece of fleece fabric and cut your desired size. Then Place a piece of fleece on a flat surface, the right side of the fabric down. Place the second piece of film directly above the first so that the edges perfectly equal. Make sure the top layer of the sweatshirt has the correct side of the fabric facing up, in front of you. Take a ruler and a square measuring 2-inch-by-2-inch at an angle. Cut this section. Repeat with all angles so you are left with four corners missing.
Take the ruler and place it along one side of the fabric. Measuring a centimeter and a half. The four centimeter cut line in the tissue of about 2 cm to a two-inch strip. Repeat around the fabric so you have a little ‘half-inch strips. Next, take the two layers of a single strip and tie them together in a double knot. Continue around 3:30 on the sides, so you get a bit ‘opening. You have to hang a lot of double knots with small ends of the strip. Last stuff the toss pillow with cotton lining, until you achieve the desired fullness. Tie the remaining strips to close the cushion. Your toss pillows without sewing is finished now.