Moen kitchen faucet parts can be installed just like any kitchen faucet. It will vary slightly based on the unique features model. The installation process can be easy to do if you know the basics. This article will give you some steps to install a single handle Moen kitchen faucet parts. The Moen kitchen faucet parts have a few installation options which can accommodate a built in soap dispenser and any other accessories. So before you start the installation you should determine how many holes that will be filling based on that kitchen sink configuration and personal preferences.
First step you should do in order to install Moen kitchen faucet parts is disconnect the water supply to the old faucet. Then, remove the old faucet. This removing process may be the hardest part of the installation project. To make it easier, you can use a basin wrench to get up under the sink and remove the old nuts. Before you pull up the faucet off of the sink, unscrew the nuts holding the faucet in place. The next step is installing the faucet body. After doing the previous step, you can start to fasten the faucet. The various pieces of the mounting hardware can be collected and moved to fasten the faucet into place under the sink. Start the process by putting the large support plate into position first. After that, continue by putting into position, the round plate and large brass nut.
After that, you can start to install the faucet spray hose. Last, attach the water supply. Re-attach the water supply to finish the installation. The hot side flex line should be hooked, the hot side should be marked to the hot side angle stop valve. Onto the angle stops, tighten the flex lines with two pliers. One to hold the angle stop and another to tighten the flex line. Finish the installation by re-checking the flex lines to not get in the way of spray hose of the Moen kitchen faucet parts.