When finished, add chimney plate cover on the ceiling. Board decking areas and then repaired to the Purloins. The ceiling must be located at least by two feet by three feet and Purloins. After the whole roof is covered with boards, left the last line about two feet. This is an area for open roof using a tongue and Groove decking areas. The deck is then covered with asphalt. This system allows having a pitch view without fear of leaks. The asphalt is laid with overlaps and a blowtorch used to seal the joints. It is also done along the chimney through the roof or wall. Then place on the asphalt shingles. They lay with overlaps about two inches.
The roof of the tree can be shaped to have numerous aesthetic features. These range from hidden gutter fascia boards not on the roof. Wrought iron wood chimney plate cover is used on the roof open. The ceiling is visible under the decking planks or tongue and Groove structures. Hidden drain pipes repaired before taken. Then they have a pipeline to take water from the fabric of the building. Rafter cut at ninety degrees instead of follow the backrest inclination on the roof. Construction of roof shingles began after Ray ring. Wall plate is anchored to the beams with bolts or other methods are suitable and approved. After the fixing of those plates of the walls, the roof structure is carried out by the ceiling and Struts for design.
Chimney plate cover – The roof can be design to be flat, conical shaped, accumulating or slapped. The construction business has evolved from a traditional iron sheet roofing tiles of modern technology. This can be a stone lined sheet, clay or concrete tiles, concrete and shingles. A second design also allows the use of integrated materials. It can be utilised as wood decking areas, bitumen as the bottom layer and shingles as a cover. Can wood tongue and Groove or chip boards.